The TentBox Classic 1.0 Adaptor Kit is designed to seamlessly connect the Tunnel Awning and Living Pod accessories to our original TentBox model.
It’s easy to install in just a few steps. Here’s how.
What’s included?
- C-Channel rail
- Guide stickers
- Alcohol wipe
- Rubber bungs
- Adaptor sleeve
Step-by-step instructions
- Unpack the Adaptor Kit and check for all parts.
- Locate the stickers from the package (2x end stickers and 1x centre sticker).
- Using an alcohol wipe, clean the surface of the TentBox in preparation for the stickers.
- Stick the stickers down, making sure the bottom aligns with the bottom of the bumper rail and the arrow on the centre sticker aligns with the middle screw.
- Prepare surface for the C-Channel rail with the alcohol wipe.
- Align the C-Channel rail with the stickers and stick down. The adhesive will set after approximately 5 minutes, but will fully cure within 24 hours. We advise waiting for full curing before attaching the Tunnel Awning or Living Pod.
- Slide on the sleeve and plug in the ends with the provided bungs.
- Proceed to set up either the Tunnel Awning or Living Pod as per instructions.
Additional support
If you have any further questions about your TentBox Classic 1.0 Adaptor Kit, get in touch with our team of friendly Product Specialists. We’re here to help.