TentBox Cargo 1.0 Adaptor Kit

The TentBox Cargo 1.0 Adaptor Kit is designed to seamlessly connect the Tunnel Awning accessory to our original TentBox model.

It’s easy to install in just a few steps. Here’s how.

What’s included?

  • C-Channel rail
  • Alcohol wipe
  • Adaptor sleeve
  • Rubber bungs
  • Extension kit

Step-by-step instructions

  1. Unpack the tube and check for all parts.
  2. Prepare surface for placing C-channel rail using the alcohol wipe.
  3. Centre C-Channel rail in position.
  4. Remove the protective backing and stick down the C-Channel rail.
  5. Allow the adhesive to set for 5-10 minutes before proceeding.
  6. Insert the adaptor sleeve into the channel with loops facing down.
  7. Plug in the ends using the provided bungs.
  8. Proceed to assemble the Tunnel Awning as usual.
  9. Slide the extension kit into the accessory rail on the Cargo.
  10. Connect the other end of the extension kit to the Tunnel Awning.
  11. Slide the handle until the awning is tight, then tighten the handle.

Additional support

If you have any further questions about your TentBox Cargo 1.0 Adaptor Kit, get in touch with our team of friendly Product Specialists. We’re here to help.