Security Alarm installation guide

Check out our handy video below to learn how to install and use your TentBox Security Alarm.

Video guide

Adjusting volume

1. Press and hold the disarm button (open padlock) until the LED turns off and on again, then release the button.
2. You have now entered the "settings" mode.
3. Press the bell button to cycle through the 3 volume options (from high to low).
4. Once you have chosen your desired volume setting, wait a few seconds for the LED to turn off. The new setting has been saved and you can use the alarm as normal.

Adjusting sensitivity

1. Press and hold the disarm button (open padlock) until the LED turns off and on again, then release the button.
2. You have now entered the "settings" mode.
3. Press the arm button (closed padlock) to cycle through the 7 sensitivity options. The higher pitched sound means higher sensitivity.
4. Once you have chosen your desired sensitivty setting, wait a few seconds for the LED to turn off. The new setting has been saved and you can use the alarm as normal.